![]() Otherwise, the machine tool may malfunction. Adaptation must be carried out properly by authorized personnel employed by, for example, Siemens, the machine tool manufacturer, or the dealer during adaptation, the defaults specified by Siemens and the machine tool manufacturer must be adhered to. The programs created using the software must only be used for production with machine tools if the software (SinuTrain/JobShop) has been adapted for the SINUMERIK controller on which the program is intended to run. Legal basics SinuTrain™ software is used for creating and simulating NC programs on a PC, on the basis of the DIN 66025 programming language as well the products ShopMill, ShopTurn and ManualTurn, and language commands of the type SINUMERIK™ 802D, 810D, 840D, 840Di. MS-DOS and WINDOWSTM are registered trademarks of the Microsoft Corporation. Trademarks IBM is a registered trademark of the International Business Corporation. This symbol always appears in this documentation where further, explanatory information is provided. This symbol indicates that an undesirable result or state may result if proper precautions are not taken. This symbol (without a warning triangle) indicates that damage to property may result if proper precautions are not taken. This symbol (with a warning triangle) indicates that minor injury or damage to property may result if proper precautions are not taken. All rights reserved EN/iv SinuTrain Getting Started (BAK) – 01.05 Edition This symbol indicates that death, severe personal injury or substantial property damage may result if proper precautions are not taken. This symbol indicates that death, severe personal injury or substantial property damage will result if proper precautions are not taken. Hotline Should you have any questions about the software, please contact the following hotline: A&D Technical Support Phone: +49 (0) 180 / 5050 - 222 Fax: +49 (0) 180 / 5050 - 223 Should you have any questions about the documentation, please contact: Fax: +49 (0) 9131 / 98 - 2176 E-mail: ĭanger and warning concept The following danger and warning symbols are used in this document: Sales staff for the purpose of giving customer presentations.Who is the SinuTrain CD designed for? This multimedia SinuTrain CD has been designed for the training and further training of: Ordering information appears in the Appendix to this Manual. ![]() Working with the examples provided If you want to further your knowledge, we recommend studying the training booklets, which have been specially developed for the training CD.Installing the training software from the CD.“Getting Started” guides you step-by-step through the following tasks: Welcome to “Getting Started” for the SinuTrain PC-based Training and Programming CD, which will enable you to operate and program SINUMERIK 802D/810D/840D/840Di controllers. All rights reserved SinuTrain Getting Started (BAK) – 01.05 Edition EN/iii
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |